Counter; Life-Replace-Fuser Unit; Life-Replace-Trans. Belt; Life-Replace-Trans. Roller - Konica Minolta BIZHUB C3100P Service Manual

3.7 COUNTER

3.7.1 LIFE-REPLACE-FUSER UNIT

(1) Use
• Resets the fuser unit counter.
• To use when the fuser unit has been replaced.
(2) Procedure
1. Call [SERVICE MODE] to the display.
2. Select [COUNTER] -> [LIFE] -> [REPLACE] -> [FUSER UNIT], and select "YES".
3. Press the Menu/Select key and reset the counter.

3.7.2 LIFE-REPLACE-TRANS. BELT

(1) Use
• Resets the transfer belt unit counter.
• To use when the transfer belt unit has been replaced.
(2) Procedure
1. Call [SERVICE MODE] to the display.
2. Select [COUNTER] -> [LIFE] -> [REPLACE] -> [TRANS. BELT], and select "YES."
3. Press the Menu/Select key and reset the counter.

3.7.3 LIFE-REPLACE-TRANS. ROLLER

(1) Use
• Resets the transfer roller unit counter.
• To use when the transfer roller unit has been replaced.
(2) Procedure
1. Call [SERVICE MODE] to the display.
2. Select [COUNTER] -> [LIFE] -> [REPLACE] -> [TRANS. ROLLER], and select "YES."
3. Press the Menu/Select key and reset the counter.

3.8 PRINT MENU

3.8.1 MANAGEMENT LIST

(1) Use
• To output the machine status, setting information on service mode and counter information in a list.
• To be used after setup.
• To be used at occurrence of a trouble.
• To produce an output of a list of Software Switch Setting.
(2) Procedure
1. Load the A4 or 8 1/2 x 11 plain paper to a paper source.
2. Select [PRINT] and press the Menu/Select key.

3.8.2 HALFTONE 64

(1) Use
• Prints the halftone pattern with 25% level for CMYK respectively.
• To check the unevenness of the density and the pitch.
(2) Procedure
1. Set the A4 or Letter paper on the tray.
2. Call [SERVICE MODE] to the display.
3. Select [PRINT MENU] -> [HALF TONE 64] and press the Menu/Select key.
4. Select the desired color.
5. Select [PRINT] and press the Menu/Select key.

3.8.3 HALFTONE 128

(1) Use
• Prints the halftone pattern with 50% level for CMYK respectively.
• To check the unevenness of the density and the pitch.
(2) Procedure
1. Set the A4 or Letter paper on the tray.
2. Call [SERVICE MODE] to the display.
3. Select [PRINT MENU] -> [HALF TONE 128] and press the Menu/Select key.
4. Select the desired color.
5. Select [PRINT] and press the Menu/Select key.
I ADJUSTMENT/SETTING > 3. SERVICE MODE
I-19