Konica Minolta BIZHUB C3100P Service Manual page 83

[2]
[1]
[1]
8. Install the new MFP board.
9. Install the removed SSD board on the new MFP board.
10. Connect the MFP board to the disconnected connectors and flat cables.
11. Turn ON the power switch.
NOTE
• Do not perform any printing operation at this stage.
12. Call [SERVICE MODE] to the display.
13. Select [Switch 7] in [SYSTEM 2] -> [SOFT SWITCH], change setting value to [159].
NOTE
• When the optional hard disk HD-P06 is installed, although a service call D093 occurs, you can
14. Turn OFF the power switch.
[1]
[1]
[2]
A
16. Turn ON the power switch.
17. Counter data starts to be backed up.
NOTE
• Do not perform any printing operation at this stage.
• Do not turn OFF the power switch during the backup process.
[3]
A
G DISASSEMBLING/REASSEMBLING > 5. Disassembly/reassembly
6. Disconnect all connectors and flat cables.
7. Remove eight screws [1] and two screws [2], and remove the MFP
board [3].
15. Remove the new EEPROM [1] from the MFP board, and mount the
old EEPROM [2] that is located on the old MFP board.
NOTE
• When mounting EEPROM (IC15), make sure the notches
("A") are precisely lined up.
G-10
procedure (b...
enter the service mode as it is.