Konica Minolta BIZHUB C3100P Service Manual page 210

Near life display: Enabled
Life display: Enabled
Life end display: Enabled
(1) Life determination
• The life of the imaging unit is determined based on the transport motor drive time, color PC drum motor drive time, and the number of
printed pages produced.
(2) Life determination timing
• The life determination control is performed under any of the following conditions:
"The power switch is turned ON (with the front door and right door are closed)"
"The machine exits the sleep mode"
"The front door or right door is opened and closed with the power switch in ON position"
(3) Life display (Display and settings for unit to be replaced)
(a) Near life display
• The default setting for the near life display in this machine is "enabled". The near life display setting can still be set to be disabled.
Make this setting as necessary.
(b) Life display
• When any one of the transport motor drive time, color PC drum motor drive time, and the number of printed pages produced reaches a
life value, the life message is displayed on the control panel.
(c) Life end diplay
• When the life end display value is reached, the machine gives a message that prompts the user to replace the imaging unit with a new
one and prohibits all print cycles. The replacement of the imaging unit with a new one cancels the printing prohibited condition.
(d) Extension of life end display
• The number of printed pages to be produced between "life display" and "life end display (print prohibited)" can be set.
For details, see I.3.3.14 IU YIELD SETTINGS
[SERVICE MODE]->[SYSTEM 2]->[ENABLE WARNING]
and make the setting as necessary.
O-9
O THEORY OF OPERATION bizhub C3100P > 3. PHOTO
CONDUCTOR SECTION