Field Service Ver. 2.0 Jun. 2010
11.4.15
TCR GAIN
A. Use
• To manually adjust the TCR sensor voltage.
• To set the TCR sensor control voltage again if the voltage determined by TCR AUTO
ADJUST is cleared due to the replacement of the printer control board or memory clear.
B. Procedure
• The default setting is 140 (3.624 V).
• The adjusted value of the TCR auto adjust is the setting value.
11.4.16
MODEL SETTING
NOTE
• Never change this setting.
1
• Default setting depend on the marketing area setting.
11.4.17
CUSTOMER ID
NOTE
• Never change this setting.
• The default setting is 0.
11.5 COUNTER
11.5.1
TOTAL COUNTER
A. Use
• To display the total count value of the selected mode.
• To check total count value in each mode.
• Counting method is different depending on the settings of [SECURITY] → [TOTAL
COUNTER COUNT] in the service mode.
See P.119
B. Procedure
COPY
PRINT
11.5.2
SIZE COUNTER
A. Use
• To display the count of the size counter.
• Paper sizes on which counting can be made are different depending on the setting of
[SECURITY] → [SIZE COUNTER] in the service mode.
• To clear the count, use [CLEAR DATA] of the SERVICE MODE.
90 (2.329 V) to 190 (4.917 V) (1 step: 0.026 V)
18 ppm/16 ppm
: Total count value in copy mode
: Total count value in PC print mode
11. SERVICE MODE
107
1