Inspec Tion A Nd Disa Ssembl Y - Suzuki DR350 Service Manual

I N SPECT I O N A N D DISAS S E M B LY
WHEEL BEARING
I nspect the play of bearing inner ring by hand while mount­
ed in the whee l .
Rotate the inner ring by hand to inspect i f any abnormal noise
occurs or rotating smoothly.
Replace the bearing if there is anything u n u s u a l .
•
Drive out t h e both bearing with t h e special too l in the foll­
woing procedures.
•
•
0994 1 -50 1 1 0 : Bearing remover
• Insert the adapter into the bearing .
After inserting the wedge bar from the opposit side, lock
the wedge bar in the slit of the adapter.
D rive out the bearing by knocking the wedge bar.
CAUTION :
The removed bearing should be replaced with new ones.
AXLE SHAFT
Check the axle shaft runout with a dial gauge and replace
it if the runout exceeds the l i m it .
:
Service Limit : 0 . 25 mm ( 0 . 0 1 0 in)
:
0 9900-20606 Dial gauge ( 1 / 1 00 mm)
l
09900-2070 : Magnetic stand
09900-2 1 304 'V' block set
WHEEL RIM
M ake sure that the wheel rim runout does not exceed the
service l imit when checked as show n .
As excessive runout is u s u a l l y d u e t o worn or loose wheel
bearings and can be reduced by repl acing the bearings. If
bearing replacement fails to red u ce the runout, replace the
wheel .
Service Limit : 2 . 0 mm ( 0 . 08 in)
(Axial and Radial)
CHASSIS 6·2
Play