Command Overview - WAGO -I/O-SYSTEM 750 Manual

62 • 750-636 [DC Drive Controller]
Configuration of the I/O Module via the Parameter Channel
Register
2.1.1.10.6.4.3

Command Overview

The following tables show the relevant commands for register 3 and the
expected corresponding acknowledgement data in register 4, for both a
positive and negative acknowledgement.
Command (request reg. 3)
REQ_RESTORE_USER
REQ_STORE_USER
REQ_RESTORE_FACTORY
Response (acknowledgement reg. 4)
RES_RESTORE_USER_OK
RES_RESTORE_USER_NOK
RES_STORE_USER_OK
RES_STORE_USER_NOK
RES_RESTORE_FACTORY_OK
RES_RESTORE_FACTORY_NOK
Bit 8 ... 15 Bit 0 ... 7
3 Session Request
4 Session Response
Value Description
0x02 The module accepts the user parameter set
(2) (NV Mem) as Actual (1).
0x03 The module stores Actual (1) as user settings
(2).
0x04 The module accepts the factory settings (3)
as Actual (1).
Value Description
0x08 Positive acknowledgement for data transfer
after REQ_RESTORE_USER command
0x09 Negative (in case of invalid data)
acknowledgement for data transfer after
REQ_RESTORE_USER command
0x0A Positive acknowledgement for data transfer
after REQ_STORE_USER command
0x0B Negative (in case of invalid data)
acknowledgement for data transfer after
REQ_STORE_USER command
0x0C Positive acknowledgement for data transfer
after REQ_RESTORE_FACTORY
command
0x0D Negative (in case of invalid data)
acknowledgement for data transfer after
REQ_RESTORE_FACTORY command
WAGO-I/O-SYSTEM 750
I/O-Modules