WAGO -I/O-SYSTEM 750 Manual page 20

20 • 750-636 [DC Drive Controller]
Process Image
Reg_Com
Switch
PresetInput
_Enabled
Optimize_On
ExtendedInfo
_On
PWM_Active
CurrentControl
_ON
PresetInput
LimitSwitch_
Pos
LimitSwitch_
Neg
Register communication (see section 2.1.1.10.4).
0: Process data communication enabled.
1: Register communication enabled.
Bit 7 Bit 6 Bit 5
Limit Limit Preset
Switch Input
_Neg _Pos
This bit indicates that the preset input is enabled.
0: Preset input is not enabled.
1: Preset input is enabled.
This bit indicates prestop optimization during the positioning process.
0: Prestop is not optimized.
1: Prestop is optimized.
This bit indicates that the data in the input process image (byte 2 to 5)
was changed.
0: Extended status information disabled.
1: Extended status information enabled.
This bit indicates if the DC Drive Controller has generated a PWM
signal at the motor output.
0: No PWM signal at the motor output.
1: PWM signal at the motor output.
This bit indicates if the motor final stage is operated with
CurrentControl_PWM.
0: Motor final stage is not operated with CurrentControl_PWM.
1: Motor final stage is operated with CurrentControl_PWM.
This bit indicates the input status of the preset switch.
0: Signal voltage (0) at the input.
1: Signal voltage (1) at the input.
This bit indicates the input status of the positive limit switch.
0: Signal voltage (0) at the input.
1: Signal voltage (1) at the input.
This bit indicates the input status of the negative limit switch.
0: Signal voltage (0) at the input.
1: Signal voltage (1) at the input.
Status byte S1
Bit 4 Bit 3 Bit 2
Current PWM_ Extended
Control Active Info_On
_ON
Bit 1 Bit 0
Optimize Preset
_On Input
_Enabled
WAGO-I/O-SYSTEM 750
I/O-Modules