Indicators; Operating Elements - WAGO -I/O-SYSTEM 750 Manual

10 • 750-636 [DC Drive Controller]

Indicators

2.1.1.4 Indicators
13 14
A
B
C
D
Fig. 2.1.1-3: Indicators
2.1.1.5

Operating Elements

The 750-636 DC Drive Controller has no operating elements. The
configuration and the parameters can be changed via higher-level control or
the WAGO-I/O-CHECK configuration tool.
LED Name
A LimitSwitch
green _Pos
B LimitSwitch
green _Neg
C
PresetInput
green
D
24 V Ok
green
E
F
E PWM_
G
yellow Active
H
g063602x
F
OnTarget
yellow
G
Reserved
red
H
Error
red
Status Function
off Input E+: Signal voltage (0)
on Input E+: Signal voltage (1)
off Input E-: Signal voltage (0)
on Input E-: Signal voltage (1)
off Input P: Signal voltage (0)
on Input P: Signal voltage (1)
off No motor operating voltage
on Motor operating voltage available
off Motor control without PWM (0 % or 100 %)
Motor control with PWM >0 % and <100 %
on
(current limitation)
off Actual position is not setpoint position
on Actual position is setpoint position
5 Hz
Positioning drive enabled
blinking
off
No function
on
off No error
on Internal error or H-bridge diagnostic signal
WAGO-I/O-SYSTEM 750
I/O-Modules