Disconnecting/Connecting Of Flexible Card Wires - Sony BVP-550 Maintenance Manual

2-8. Disconnecting/Connecting of Flexible Card Wires

2-8. Disconnecting/Connecting of
Flexible Card Wires
The flexible card wires are used between the MB-602
board and the CCD unit, the MB-602 board and the CN-
1120/1121/1122/PR-211 boards. Be careful not to bend
these wires. This shortens the wire life.
Disconnecting
1. Turn off the power of the camera.
Type A
(between the MB-602 board and CCD unit)
2. Lift up the portion A in the direction of the arrow and
disconnect the flexible card wire.
Type B
(between the MB-602 board and CN-1120/1121/1122/
PR-211 boards)
2. Slide portion B in the direction of the arrow and
disconnect the flexible card wire.
Connecting
m
• Be careful not to insert the flexible card wires obliquely.
• Check that the conductive surface of the flexible card
wire is not soiled with dust.
Type A
(between the MB-602 board and CCD unit)
1. Lift up the portion A in the direction of the arrow.
Insert the flexible card wire as far as it will go into
connector with the conductive surface of the wire put
down.
2. Push down the portion A to secure the flexible card
wire.
Type B
(between the MB-602 board and CN-1120/1121/1122/
PR-211boards)
1. Slide portion B in the direction of the arrow and insert
the flexible card wire as far as it will go into connector
with the conductive surface of the wire put down.
2. Slide portion B in the opposite direction of the arrow
and lock each connector.
2-10 (E)
Type A
Conductive surface
MB-602&OHB
Type B
B
MB-602&CN-1120/1121/1122/PR-211
A
B
Conductive surface
BVP-550