3-1. Setup Menu
The Setup menu is used to select settings of camera operation, select items to be displayed on the view-
finder screen, and select the way the items are displayed.
It is also used for adjustment. The menu appears on the viewfinder screen.
By changing a setting through this menu, the same signal as output to the viewfinder is enabled to be
output at the TEST OUT connector.
•
Configuration of the Setup Menu
The setup menu consists of the following menus
• Operation menu
• Paint menu
• Maintenance menu
• Reference menu
• Triming menu
• System config menu
Operation and Paint menus are normally accessible. To display the other menus, switch setting of the
AT-95 board is required. For details, refer to Section 1-3. "Function of Internal Switches—AT-95 board"
•
Equipment required
CCD Unit
OHB-450/550 series
Camera Adaptor CA-550/550P
Supply power from a camera control unit CCU-700/700P, AC adaptor AC-550/550CE or VTR.
•
Switches and Button
MENU SEL switch
BVP-550
Setup Menu
DISP switch
DISP
ON
OFF
MENU
MIC
LEVEL
<FRONT VIEW>
Section 3
CANCEL button
CANCEL
3-1(E)