Disconnecting/Connecting Flexible Card Wire - Sony BVP-500 Maintenance Manual

2-5. Disconnecting/Connecting Flexible Card Wire

2-5. Disconnecting/Connecting Flexible
Card Wire
The flexible card wires are used between the MB-637 and
CCD unit(OHB), MB-637 and SW-795 boards and MB-
637 and PR-211 board respectively. Take care not to break
these flexible card wires. This shorten the wire life.
Disconnecting
1. Turn off the power.
Type A
(between MB-637 and CCD unit, and between MB-637
and SW-795)
2. Lift up the portion A in the direciton of the arrow and
disconnect the flexible card wire.
Type B
(between MB-637 and PR-211)
2. Slide portions B in the direciton of the arrow to unlock
and pull out the flexible card wire.
Connecting
m
• Be careful not to insert the flexible card wire obliquely.
• Check that the conductive surface of the flexible card
wire is not soiled with dust.
Type A
1. Lift up the portion A in the direction of the arrow and
insert the flexible card wire as far as it will go with the
conductive surface down.
2. Push down the portion A to secure the flexible card
wire.
Type B
1. Slide portions B in the direction of the arrow and insert
the flexible card wire as far as it will go with the
conductive surface down.
2. Slide portions B in the reverse direction to lock.
2-6
Type A
Conductive surface
MB-637&OHB/SW-795
Type B
B
Conductive surface
MB-637&PR-211
A
B
BVP-500
BVP-500P