Sony BVP-550 Maintenance Manual page 915

Page Ver. Item
MATRIX G-R, B-R
R-G, B-G
R-B, G-B
MATRIX
USER
PRESET
TEST
CLEAR
SCENE FILE 1
2
3
4
5
FILE STORE
STANDARD
SHUTTER 1.10 SELECT
1.10 SHUTTER
1.10 ECS
1.10 S-EVS
OTHERS 1.09 16:9/4:3 MODE
f) When both USER and PRESET are set to ON, the matrix constant compensation is total value of the USER and PRESET matrix.
h) Variable range differs depending on the OHB in use. For details refer to the operation manual supplied with the OHB.
i) The aspect ratio normally corresponds to the CCU's setting when the CCU is connected. To forcefully select, use this menu.
BVP-550
Settings
–99 to 99 ([0])
–99 to 99 ([0])
–99 to 99 ([0])
[ON], OFF
[ON], OFF
f)
[ON], OFF
f)
1, 2, [OFF]
Press MENU SEL
switch to execute.
Storing and recalling a scene file (painting data corresponding to a shot scene)
Storing a scene file
1 Turn MENU SEL switch to move the → cursor to "FILE STORE," then press MENU SEL
switch. "FILE STORE" flashes on the viewfinder screen.
2 Select the file number (1 to 5) to be stored to.
(If data is already stored at the selected location, the new data replaces the current data.)
Recalling a scene file
Turn MENU SEL switch to move the → cursor to the file number whose data is to be recalled,
then press MENU SEL switch.
• When MENU SEL switch is pressed, the scene file data replaces the current settings.
• When the scene file is recalled, an asterisk appears next to the number.
Returns the current amount of paint adjustments and switch setting to their reference value
stored as a reference file.
[OFF], SHUTTER,
EVS, ECS
(or ), , ,
1 1 1 1
100 60 125 250
1 , 1 , 1
500 1000 2000
h)
[0] to 100%
[16:9], 4:3
Contents
Compensates the user's matrix (sets an optional value as the constant
for G-R, B-R, R-G, B-G, R-B, and G-B).
Turns the matrix compensation on and off.
Turns the user's matrix compensation on and off.
Turns on and off only the preset matrix compensation (fixed constant
compensation).
Selects the test signal.
1 : Outputs the sawtooth waveform test signal
2 : Outputs 3-step form test signal
OFF : No test signal is output
Sets all settings on the MATRIX page to 0.
(When you press MENU SEL switch, the "CLEAR" indication flashes.
Press MENU SEL switch again to execute; press CANCEL button to cancel.)
Selects the shutter, EVS, or ECS mode. (Does not correspond to the
setting of the SHUTTER switch in the camera front.)
Selects the shutter speed.
Sets the ECS (CLS) frequency.
Sets the desired resolution in %.
(This setting is invalid with the OHB-450/450P/451/451P installed.)
Selects the aspect ratio for the video signal output.
3-1. Setup Menu
3-1-2. Paint Menu
i)
3-9(E)