2-11. Replacement of DC/DC Convertor
Unit
1. Remove the right and left side panels of the camera.
(Refer to "2-2. Removal of Cabinet".)
2. Remove the two screws on the left side of the camera
shown in the figure.
BVP-550
BVP-550P
3. Thread the two screws that were removed in Step 2,
into the holes of the DC/DC convertor unit three turns.
n
Never turn the two screws more than three turns.
4. Hold the two screws with hands and remove the DC/
DC convertor unit.
X
B2.6
5
5. Install a new DC/DC convertor unit pushing with
hands.
Secure it to the MB-602 board with the two screws
that were removed in Step 2.
2-11. Replacement of DC/DC Convertor Unit
DC/DC
Convertor Unit
2-15 (E)