Sony BVP-550 Maintenance Manual page 732

4-2. Adjustment for Installation of OHB
4-2-18. Menu Settings After Finishing Adjustment
4-2-19. File Store
4-3. Overall Electrical Alignment
4-2-18. Menu Settings After Finishing
Adjustment
MENU : Paint
PAGE : Detail 1 (P2)
: Detail → On
ITEM
PAGE : Gamma (P5)
: Gamma → On
ITEM
PAGE : Knee/W.Clip (P6)
: Knee → On
ITEM
4-2-19. File Store
Be sure to execute the file store after any one of the
adjustments of Sections 4-2-1 through 4-2-17 is performed.
Procedures:
1. Set the DISP switch (on the side panel) to MENU
while holding down the MENU SEL switch (on the
front panel).
2. Execute the reference file store. Press the MENU SEL
switch to execute.
Menu Setting:
MENU : Reference File
PAGE : Reference File (R1)
ITEM : File Store
3. Execute the triming file store. Press the MENU SEL
switch to execute.
Menu Setting:
MENU : Triming File
PAGE : Triming File (T1)
ITEM : File Store
4-22 (E)
4-3. Overall Electrical Alignment
Before beginning this adjustment, check the initial settings
referring to Section 4-1-5. When a board was replaced or
repaired, preset the compensation data, proceeding as
follows. If the data is preset once, be sure to carry out all
steps of 4-3-1 through 4-3-23. Because presetting clears all
adjustment data of video and detail system.
(1) Execute the reference file clear.
Press the MENU SEL switch to execute.
MENU : Reference File
PAGE : Reference File (R1)
ITEM : Clear File
(2) Execute the scene file standard.
Press the MENU SEL switch to execute.
MENU : Paint
PAGE : Scene File (P8)
ITEM : Standard
This section provides intructions to store the setting data
on the reference or triming file in every adjustment item.
This intends to prevent the data from being cleared when
the unit is powered off to extend a board, and so on.
As the data is kept held unless powered off, however, more
than one data can be stored at a time.
The file store may not necessarily be executed for every
adjustment item.
BVP-550