Table of Contents
Advertisement
Chapter 9: Powering On the Chassis
192
Figure 135. Tightening the Handle Locking Screw
10. Before attaching the power wires from the power supply to the circuit
breaker in the wiring closet, check that the circuit breaker is off.
11. Connect the power wires to the circuit breaker.
12. Turn the circuit breaker on.
13. Turn the On/Off switch on the power supply in the chassis to the On
position. See Figure 129 on page 187.
14. Do one of the following:
If the chassis has two AT-SBxPWRSYS1 DC Power Supplies,
repeat this procedure to power on the second power supply.
Otherwise, go to "Monitoring the Initialization Process" on
page 203.
Handle locking
screw
Advertisement
Table of Contents
