Table of Contents
Advertisement
Chapter 11: Upgrading to the AT-SBx31CFC960 Card from the AT-SBx31CFC Card
226
Note
If in step 15 you included the OUTPUT option with the RESTORE
CONFIG command to create an output file, perform step 17. If you
did not include the option, go to step 18.
17. If in step 15 you included the OUTPUT option with the RESTORE
CONFIG command to create an output file, do the following:
a. Use the PUT FILE command to download the output file created by
the OUTPUT option in step 15 to a network server. This example
of the command downloads an output file called results.txt from the
controller card to a TFTP server:
put file=results.txt tftp server=149.135.78.12
b. Open the file with a word processor or text editor and examine the
output for error messages. If there are no error messages,
continue with this procedure. If there are error messages, contact
Allied Telesis for assistance.
18. Verify the hardware operations of the unit by performing the
instructions in Chapter 10, "Verifying the Hardware Operations of the
Chassis" on page 209.
19. From a local or remote management session, use the appropriate
SHOW commands to confirm the configuration settings of the
controller and Ethernet line cards. For instructions, refer to Software
Reference for SwitchBlade x3100 Series Switches.
Note
If the chassis was previously using the DHCP relay filtering option,
continue with this procedure to reactivate it on the ports. If the
chassis was not using the filtering option, the upgrade is complete.
20. Before reactivating the DHCP relay filtering option on the ports, wait
for the longest lease time on the network to expire. This information is
available on the DHCP server. For example, you should wait 12 hours
if that is the longest lease time.
21. After waiting the longest lease time, use the SET DHCPRELAY
INTERFACE command to reactivate the DHCP relay filtering option on
those ports you noted in step 2c. This example of the command
enables filtering on port 1.2:
set dhcprelay interface=1.2 filter=on
This completes the upgrade procedure.
Advertisement
Table of Contents
