Table of Contents
Advertisement
Chapter 8: Installing the Transceivers and Cabling the Ports
168
Figure 109. Removing the Dust Cover from an SFP or SFP+ Transceiver
in the AT-SBx31CFC960 Controller Fabric Card
Note
The dust cover protects the fiber optic port on the transceiver from
dust contamination. It should not be removed until you are ready to
connect the fiber optic cable.
5. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 110. The connector should snap into the port.
Figure 110. Attaching a Fiber Optic Cable to an SFP or SFP+ Transceiver
in the AT-SBx31CFC960 Controller Fabric Card
Advertisement
Table of Contents
