Table of Contents
Advertisement
Powering On the AT-SBxPWRSYS1 or AT-SBxPWRSYS2 AC System
Power Supply
SwitchBlade x3106 Chassis Switch and AT-SBx31CFC960 Card Installation Guide
The procedure in this section explains how to power on the AT-
SBxPWRSYS1 or AT-SBxPWRSYS2 AC System Power Supply in the
chassis. System power supplies provide power for all of the hardware
components of the chassis, including line cards, controller cards, and fan
module. The only component that system power supplies do not support is
the PoE feature on the ports on the AT-SBx31GP24 Line Cards. For
installation instructions, refer to "Installing the AT-SBxPWRSYS1 or AT-
SBxPWRSYS2 AC System Power Supply" on page 107.
Note
If the chassis has both system and PoE power supplies, you may
power on the power supplies in any order or simultaneously.
To power on the chassis, perform the following procedure:
1. Identify AC sockets C and D in the recessed panel on the back panel
of the chassis, shown in Figure 111. The sockets are for the system
power supplies in slots C and D on the front panel of the chassis.
Figure 111. AC Sockets on the AT-SBx3106 Chassis Rear Panel
2. Plug the AC power cord that comes with the power supply into a plug
whose corresponding slot on the front panel has a system power
supply.
If there are two system power supplies, you may power on either
supply first. The illustration in Figure 112 on page 174 shows the AC
power cord being connected to connector D for the power supply in
slot D on the front panel.
C
A
D
B
173
Advertisement
Table of Contents
