Table of Contents
Advertisement
Chapter 6: Installing the Power Supplies
Installing the AT-SBxPWRSYS1 DC System Power Supply
118
This section contains the installation procedure for the AT-SBxPWRSYS1
DC System Power Supply. For background information, refer to "Power
Supplies and Power Supply Slots" on page 24.
Here is a list of the required material and tools:
Two 8 AWG power wires
One 10 AWG grounding wire
8 mm wrench
#1 Phillips-head screwdriver
#3 Phillips-head screwdriver
#3 Phillips-head 30 to 40 inch-lbs torque screwdriver (optional)
Caution
The electronic components in the AT-SBxPWRSYS1 DC System
Power Supply can be damaged by electro-static discharges (ESD).
Follow the procedure in "Protecting Against Electrostatic Discharge
(ESD)" on page 106 to guard against ESD damage when unpacking
and installing the power supply.
To install the power supply, perform the following procedure:
1. Choose a slot in the chassis for the AT-SBxPWRSYS1 DC System
Power Supply.
You may install it in slot C or D, shown in Figure 50 on page 107. The
first AT-SBxPWRSYS1 DC System Power Supply should be installed
in slot D, because the slot does not have a blank power supply panel.
If you are installing only one power supply, you may install it in either
slot C or D.
Caution
The AT-SBxPWRSYS1 DC System Power Supply will not work in
slot A or B.
2. If the chassis already has a power supply in slot D, remove the blank
power supply panel from slot C by lifting the blank panel handle and
sliding it out of the slot, as shown in Figure 61 on page 119.
Advertisement
Table of Contents
