Table of Contents
Advertisement
Choosing a
The AT-SBxPWRSYS1 DC Power Supply comes with two sets of power
wire terminals. The terminals are shown in Figure 126. You may use either
Method for
set to connect the positive (+) and negative (-) wires to the terminal block
Attaching the
on the power supply. The straight terminals are used to route the wires
Power Wires
above or below the terminal block. The right angle terminals are used to
route the power wires directly away from the terminal block.
SwitchBlade x3106 Chassis Switch and AT-SBx31CFC960 Card Installation Guide
Figure 125. Securing the Bare Grounding Wire to the Grounding Post
Straight Terminals
Figure 126. Power Wire Terminals
Note
The right angle terminals require the removal of the plastic cover
from the terminal block.
Right Angle Terminals
185
Advertisement
Table of Contents
