Table of Contents
Advertisement
Chapter 6: Installing the Power Supplies
116
6. Lower the locking handle of the power supply module to secure the
module in the slot, as shown in Figure 60.
Figure 60. Locking the Handle on the AT-SBxPWRPOE1 AC Power
Note
If the module does not fully seat in the chassis slot, check to be sure
you are installing a AT-SBxPWRPOE1 Power Supply and not a
system power supply. The model name of the module is included on
a label on the locking handle. Refer to "Power Supplies and Power
Supply Slots" on page 24 for more information.
7. To install a second AT-SBxPWRPOE1 Power Supply, repeat this
procedure.
8. After installing the AT-SBxPWRPOE1 Power Supplies, go to Chapter
7, "Installing the AT-SBx31CFC960 Card and Ethernet Line Cards" on
page 125.
Supply
Advertisement
Table of Contents
