Setting Up Ic Pure System - Thermo Scientific dionex ic pure water Operating Instructions Manual

Step Action
1 Place the Dionex IC Pure system at the desired location
(on the workbench, under the workbench, or wall-mount).
A wall attachment kit is available for wall-mounting.
2 Remove the cover from the ultrapure cartridge by pressing
the snapper and pull the cover off toward the front.
3 a. Locate the ultrapure cartridge.
b. Place the ultrapure cartridge in the rear section of the
Note The quick-connectors are attached to the unit
in such a manner so as to prevent installing the
ultrapure cartridge incorrectly.
Note Cartridge serial number will need to be
entered in the system after power is applied.
(see"Changing the ultrapure cartridge" )
Thermo Scientific

Setting up IC Pure system

Note
Inspect the IC Pure system for any leaks after tubing has been connected and water is

introduced into the system.
To avoid tripping, ensure that the tubings and wires do not lay over the floor.

unit insert the two quick-connectors into the ultrapure
cartridge. When you hear an audible click you can be
sure that the quick-action fasteners have been
inserted correctly.
Figure
See Section "Wall Mounting IC Pure system
(optional)" .
Snapper
Cover
b.)
Installation |
Chapter 7
Ultrapure
cartidge
Dionex IC Pure system | 25