Table of Contents
Advertisement
Step
Action
1
Switch the system off.
2
Remove the cover over the pretreatment cartridge by press-
ing the snapper and pull the cover forward.
3
Press on the three quick-connectors on the cover of the
pretreatment cartridge, remove the used cartridge from the
unit and plug the inlets using the yellow plugs that you
removed when the cartridge was first installed or with the
yellow plugs that came with replacement cartridge in step 4
below.
4
Locate the new pretreatment cartridge and insert the car-
tridge into the unit.
5
Insert the quick-connectors into the connecting points on
the new pretreatment cartridge. When you hear an audible
click you can be sure that the quick-connectors have been
inserted correctly.
Note The quick-connectors are attached to the unit
in such a manner so as to prevent any confusion
(switching)
6
Put the cover back in place and switch the unit on.
Thermo Scientific
Figure
Snapper
Cover
Quick-connectors
Pretreatment
cartridge
Pretreatment
cartridge
Maintenance |
Chapter 13
Dionex IC Pure system | 81
Advertisement
Table of Contents
