Table of Contents
Advertisement
Step
Action
7
c. Connect the power to the unit (see "Mounting of the
d. Turn on the additional tank indicator located on the
Note This additional tank indicator has already been
calibrated at the factory. If recalibration is required, refer
to "Recalibration of the tank sensor for an additional tank
indicator"
Note The additional tank indicator on the unit will
switch off automatically after about 5 minutes. You can
switch the indicator back on by pressing the On/Off
button for the additional tank indicator.
8
Screw the sterile filter supplied with the unit into the
1/4" thread of the sampling tap.
Thermo Scientific
Power pack (voltage supply)" ).
front of the Dionex IC Pure system by pressing the
on/off switch. The indicator will illuminate for 5
minutes, then turn off. If the additional tank indicator
not showing the correct value from the content of 5 L
tank, calibrate the additional tank indicator new.
Figure
d.)
Additional tank
indicator
Installation |
Chapter 7
1/4" thread
Sterile filter
Dionex IC Pure system | 27
Advertisement
Table of Contents
