Thermo Scientific dionex ic pure water Operating Instructions Manual page 50

Chapter 7
| Installation
11 Under "Properties", scroll down and open the tab "State Devices".
12 Check the box for "Pump_ECD_Relay_2". For "State Device tab" for the
Dionex ICS-4000 system check the box for "Pump_Relay_1"
Note If you are in the "Relays" menu of the Chromeleon
software for the Dionex ICS-5000
ICS-3000 system, check the box for:
13 Either double-click or press the F2 button on the unit names to go to the
'Device Configuration Panel'.
14 Place a check mark in the box for "Flow Zero".
See "Sample Chromeleon CDS Software settings for Dionex ICS-2100,
Dionex ICS-4000 system"
15 Save your settings and exit the configuration settings. The Dionex
Integrion and Dionex ICS-2100, Dionex ICS-4000, Dionex ICS-5000
Dionex ICS-5000 or Dionex ICS-3000 system will then pump pure
water from the Dionex IC Pure system.
|
Dionex IC Pure system
40
a. "Pump_Relay_4", if you are using the bottom Dual
Pump and
b. "Pump_Relay_2", if you are using the top Dual Pump.
.
+
, Dionex ICS-5000 or Dionex
See "Sample Chromeleon CDS Software settings
for Dionex ICS-2100, Dionex ICS-4000 system" .
See "Sample Chromeleon CDS Software settings
for Dionex ICS-5000+, Dionex ICS-5000 and
Dionex ICS-3000 system" .
See "Sample Chromeleon CDS Software settings
for Dionex ICS-5000+, Dionex ICS-5000 and
Dionex ICS-3000 system" .
+
,
Thermo Scientific