Table of Contents
Advertisement
Chapter 7
|
Installation
Step
Action
4
If you are using a pretreatment cartridge in the Dionex IC Pure
system, remove the tube jumper at the left concentrate connection
on the unit and route a o.d. 8 mm (0.31 in) tube to the drain.
Note An illustration of the drain is given under
"Illustration of drain" .
5
a.
Note The power supply for the external 20 L tank
with level control is delivered from the control wire of
the Dionex IC Pure system.
b. Switch on the power to the unit (see "Mounting of the
c. After this, switch on the additional tank indicator on the
Note This additional tank indicator has already been
calibrated at the factory. If recalibration is required refer
to "Recalibration of the tank sensor for an additional
tank indicator" .
|
Dionex IC Pure system
32
Connect the control cable from the Dionex IC Pure
system to the electrical connector of the external 20 L
tank.
Power pack (voltage supply)" )
unit and check the filling level.
Figure
Concentrate connection on the unit
o.d. 8 mm (0.31 in) tube
a.)
Electrical connection port
IC Pure system
control cable
c.)
Additional tank
indicator
Electrical connection
port 20 L tank
Thermo Scientific
Advertisement
Table of Contents
