Table of Contents
Advertisement
Chapter 7
|
Installation
Step
Action
4
a. At the
b. Attach the d8 mm (0.31 in) with quick disconnect
.
Note If using IC Pure system with internal 5 L tank,
follow steps 5 - 7.
If using IC pure system with external 20 L tank skip
steps 5 and 6.
5
Connect short jumper cable into 5 pin "tube jumper" and 6 pin
"level switch external tank" on right side of IC Pure system.
6
Unscrew the cover for the internal 5 L feedwater tank and
fill the tank with pretreated water, or with potable water
when you are using a pretreatment cartridge.
|
Dionex IC Pure system
26
"OUT"
connection on right side of the IC Pure
unit insert the d8 mm (0.31 in) tube with quick
disconnect supplied with the unit into this
connection. When you hear an audible click you can
be sure that the quick-connectors have been inserted
correctly. Route the tube with a downward slope to the
drain (see "Illustration of drain" ).
tube to the overflow nozzle on the tank on the unit and
route the tube with a downward slope to the drain
CAUTION When using the unit without a
pretreatment cartridge, only feedwater that
has been pretreated by reverse osmosis, ion
exchange or distillation is to be used.
Figure
a.)
OUT connection
tube jumper
OUT connection
tubing, diam. 8 mm
(0.31 in)
b.)
5 pin
Jumper cable
Lid
5 L tank
put in here
the tubing,
diam. 8 mm (0.31 in)
6 pin
Thermo Scientific
Advertisement
Table of Contents
