Thermo Scientific dionex ic pure water Operating Instructions Manual page 17

Thermo Scientific
Wear safety gloves when working with chlorine granulate or with disinfectant solutions.

If your skin should come into contact with a chlorine product, immediately rinse it with

ample, fresh water.
The unit, or system components, may heat up as a result of a defect. It is recommended to

always wear appropriate safety gloves to prevent skin damage or burns.
Wear safety gloves when changing the UV-lamp, to prevent that your skin comes in contact

with the UV-lamp glass.
Wear safety goggles when working with chlorine granulate or with disinfectant solutions.

If your eyes come into contact with a chlorine product, immediately rinse them with ample,

fresh water and immediately contact a physician.
Check the UV-lamp before initial start.

If the UV-lamp is broken

Wear a breathing protector, filter category FFP3 and replace the UV-lamp. For

disposal of the UV-lamp, refer to "Waste disposal" on page 97.
Ventilate the room well.

Note The Hg content in the UV-lamp is so low so that no damage to the environment can arise.!
To avoid tripping ensure that the tubings do not lay over the floor.

Apply the general rules of hygiene for laboratories when working with the system.

Do not use any oxidative cleaning agents for cleaning the unit. These can damage the unit.

Proceed as follows when the unit has a defect:

Switch the system off and unplug the unit from power outlet.

Shut off the supply of feedwater.

Contact your local service organization.

Safety precautions |
Chapter 2
Dionex IC Pure system | 7