Channel­specific Machine Data - Siemens SINUMERIK 828D Function Manual

K2: Axis Types, Coordinate Systems, Frames
10.9 Data lists
Number Identifier: $MN_
18600 MM_FRAME_FINE_TRANS
18601 MM_NUM_GLOBAL_USER_FRAMES
18602 MM_NUM_GLOBAL_BASE_FRAMES
10.9.1.3 Channel­specific machine data
Number Identifier: $MC_
20050 AXCONF_GEOAX_ASSIGN_TAB
20060 AXCONF_GEOAX_NAME_TAB
20070 AXCONF_MACHAX_USED
20080 AXCONF_CHANAX_NAME_TAB
20110 RESET_MODE_MASK
20118 GEOAX_CHANGE_RESET
20126 TOOL_CARRIER_RESET_VALUE
20140 TRAFO_RESET_VALUE
20150 GCODE_RESET_VALUES
20152 GCODE_RESET_MODE
20184 TOCARR_BASE_FRAME_NUMBER
21015 INVOLUTE_RADIUS_DELTA
22532 GEOAX_CHANGE_M_CODE
22534 TRAFO_CHANGE_M_CODE
24000 FRAME_ADD_COMPONENTS
24002 CHBFRAME_RESET_MASK
24004 CHBFRAME_POWERON_MASK
24006 CHSFRAME_RESET_MASK
24007 CHSFRAME_RESET_CLEAR_MASK
24008 CHSFRAME_POWERON_MASK
24010 PFRAME_RESET_MODE
24020 FRAME_SUPPRESS_MODE
24030 FRAME_ACT_SET
24040 FRAME_ADAPT_MODE
24050 FRAME_SAA_MODE
24805 TRACYL_ROT_AX_FRAME_1
24855 TRACYL_ROT_AX_FRAME_2
24905 TRANSMIT_ROT_AX_FRAME_1
24955 TRANSMIT_ROT_AX_FRAME_2
28080 MM_NUM_USER_FRAMES
28081 MM_NUM_BASE_FRAMES
812
Description
Fine offset for FRAME (SRAM)
Number of globally predefined user frames (SRAM)
Number of global basic frames (SRAM)
Description
Assignment geometry axis to channel axis
Geometry axis name in channel
Machine axis number valid in channel
Channel axis name in the channel
Definition of basic control settings after RESET/TP-
End)
Allow automatic geometry axis change
Active toolholder on RESET
Transformation record on power-up (RESET / TP-
End)
Initial setting of the G groups
RESET response of the G Groups
Number of the basic frame for pickup of the table
offset
End point monitoring for evolvents (involutes)
M code for replacement of geometry axes
M code for transformation change
Frame components for G58 and G59
RESET response of channel­specific basic frames
Reset channel-specific basic frames after Power On
Active system frames after reset
Clear system frames on RESET
Reset system frames after POWER ON
RESET mode for programmable frame
Positions for frame suppression
SZS coordinate system setting
Adapting active frames
Saving and activating data management frames
Rotary axis offset TRACYL 1
Rotary axis offset TRACYL 2
Rotary axis offset TRANSMIT1
Rotary axis offset TRANSMIT2
Number of settable Frames (SRAM)
Number of basic frames
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions