Data Lists; Machine Data; Nc-Specific Machine Data; Channel­specific Machine Data - Siemens SINUMERIK 828D Function Manual

8.18

Data lists

8.18.1

Machine data

8.18.1.1

NC-specific machine data

Number Identifier: $MN_
10713 M_NO_FCT_STOPRE
10714 M_NO_FCT_EOP
10715 M_NO_FCT_CYCLE
11100 AUXFU_MAXNUM_GROUP_ASSIGN
11110 AUXFU_GROUP_SPEC
11450 SEARCH_RUN_MODE
8.18.1.2 Channel­specific machine data
Number Identifier: $MC_
20110 RESET_MODE_MASK
20112 START_MODE_MASK
20270 CUTTING_EDGE_DEFAULT
20800 SPF_END_TO_VDI
22000 AUXFU_ASSIGN_GROUP
22010 AUXFU_ASSIGN_TYPE
22020 AUXFU_ASSIGN_EXTENSION
22030 AUXFU_ASSIGN_VALUE
22035 AUXFU_ASSIGN_SPEC
22040 AUXFU_PREDEF_GROUP
22050 AUXFU_PREDEF_TYPE
22060 AUXFU_PREDEF_EXTENSION
22070 AUXFU_PREDEF_VALUE
22080 AUXFU_PREDEF_SPEC
22100 AUXFU_QUICK_BLOCKCHANGE
22110 AUXFU_H_TYPE_INT
22200 AUXFU_M_SYNC_TYPE
22210 AUXFU_S_SYNC_TYPE
22220 AUXFU_T_SYNC_TYPE
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
H2: Auxiliary function outputs to PLC
Description
M function with preprocessing stop
M function for spindle active after NC RESET
M function to be replaced by subroutine
Maximum number of user-defined auxiliary functions
per channel
Group-specific output behavior
Behavior after a block search
Description
Definition of control initial setting after part program
start.
Definition of control initial setting after power­up and
on RESET or at end of part program
Basic setting of tool cutting edge without programming
Subroutine end / Stop at PLC
Group assignment of user-defined auxiliary functions
Type of user-defined auxiliary functions
Address extension for user-defined auxiliary functions
Value of user-defined auxiliary functions
Output behavior of user-defined auxiliary functions
Group assignment of predefined auxiliary functions
Type of predefined auxiliary functions
Address extension for predefined auxiliary functions
Value of predefined auxiliary functions
Output behavior of predefined auxiliary functions
Block change delay with quick auxiliary functions
Type of H auxiliary functions
M functions output time
S functions output time
T functions output time
8.18 Data lists
473