Siemens SINUMERIK 828D Function Manual page 790

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

K2: Axis Types, Coordinate Systems, Frames
10.5  Frames 
The old and new X axes X and X' coincide in the projection in the direction of the old Z axis. The old and new Y
axes Y and Y' form an angle of 8.13 degrees (right angles are generally not retained in the projection).
For setting data setting:
SD42980 $SC_TOFRAME_MODE=2
, Y and Y' would coincide accordingly and X and X' would form an angle of 8.13 degrees.
For setting data setting:
SD42980 $SC_TOFRAME_MODE=3
, X and X', as well as Y and Y', would each form an angle of 4.11 degrees.
Note
The named angles (8.13 and 4.11 degrees) are the angles, which the projections of the axes
form in the X-Y plane. They are not the spatial angles of these axes.
TCARR and PAROT
Previously, TCARR has used the basic frame identified by machine data:
MD20184 $MC_TOCARR_BASE_FRAME_NUMBER
.
A system frame can be created for TCARR and PAROT alone, in order to avoid conflicts with systems, which
already use all the basic frames.
PAROT,TOROT and TOFRAME have previously changed the rotation component of the programmable frame. In
this case, it is not possible to shut down PAROT or TOROT separately. On RESET, the programmable frame is
deleted, which means the after changing the operating mode to JOG, the rotation component of PAROT and
TOROT is no longer available. The user must also have unrestricted access to the programmable frame. Frames
produced by PAROT and TOROT must be able to be archived and reloaded via data backup.
The system frame for TCARR and PAROT is configured with bit 2 in machine data:
MD28082 $MC_MM_SYSTEM_FRAME_MASK
.
Machine data:
MD20184 $MC_TOCARR_BASE_FRAME_NUMBER
is then no longer evaluated.
If the system frame for TCARR is configured, TCARR and PAROT describe that system frame; otherwise the basic
frame identified by machine data:
790
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d sl

Table of Contents