Siemens SINUMERIK 828D Function Manual page 571

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

In order that the setting of bit 8 can become effective, the measurement of the current

program runtime must be active (MD27860 bit 1 = 1).

Workpiece count

After the part program end (M02 / M30) has been attained, the activated workpiece counters

($AC_TOTAL_PARTS / $AC_ACTUAL_PARTS / $AC_SPECIAL_PARTS) are incremented by "1" (see Chapter

" Workpiece counter [Page 668] ").

Via the following machine data it can be set that the activated workpiece counter is incremented even in case of

a program restart through the function "jump back to start of program":

MD27880 $MC_PART_COUNTER (activation of workpiece counters)

In case of a program restart through the function "jump back to start of program", the

workpiece counter:

$AC_TOTAL_PARTS is not incremented.

$AC_TOTAL_PARTS is incremented.

$AC_ACTUAL_PARTS is not incremented.

$AC_ACTUAL_PARTS is incremented.

$AC_SPECIAL_PARTS is not incremented.

$AC_SPECIAL_PARTS is incremented.

The function is called in the main or the part program via the command GOTOS.

Application in synchronized actions: not possible

GOTOS internally initiates a STOPRE (pre-processing stop).

Basic Functions

Function Manual, 09/2011, 6FC5397-0BP40-2BA0

K1: Mode group, channel, program operation, reset response

; Beginning of the program

; Jump to beginning of the program

9.9 Program operation mode

Sinumerik 840d sl