Siemens SINUMERIK 828D Function Manual page 396

H2: Auxiliary function outputs to PLC
8.1 Brief description
• Identification of the tools, optionally via tool number or location number.
References:
Function Manual, Tool Management
Function Manual, Basic Functions; Tool Offset (W1)
• When T0 is selected, the current tool is removed from the tool holder but not replaced by a new tool (default
setting).
• T function-specific machine data:
MD22220 $MC_AUXFU_T_SYNC_TYPE (Output time of the T functions)
D functions
D (tool offset)
Address extension
Value range Meaning
- - - - - -
Remarks:
Clearing the tool offset with D0. Default is D1.
8)
See "Meaning of footnotes" at the end of the overview.
Application
Selection of the tool offset.
Further information
• Initial setting: D1
• After a tool change, the default tool cut can be parameterized via:
MD20270 $MC_CUTTING_EDGE_DEFAULT (Basic position of the tool cut without programming)
• Deselection of the tool offset: D0
• D function-specific machine data:
MD22250 $MC_AUXFU_D_SYNC_TYPE (Output time of the D functions)
DL functions
DL (additive tool offset)
Address extension
Value range Meaning
8)
See "Meaning of footnotes" at the end of the overview.
396
Value
Value range
0 ... 9
Value
Value range
Type Meaning
INT Selection of the tool
offset
Type Meaning
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
8)
Number
1
8)
Number
Basic Functions