Siemens SINUMERIK 828D Function Manual page 343

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Reading and writing of data in the case of G70/G71 and G700/G710 in the part program

Display, decimal places (WCS)

Display, decimal places (MCS)

Positional data X, Y, Z

Interpolation parameters I, J, K

Circle radius (CR)

Polar radius (RP)

Programmable FRAME

Settable FRAMES

Basic frames

Work offsets external

Axial preset offset

Operating range limit (G25/G26)

Protection zones

Tool offsets

Length-related machine data

Length-related setting data

Length-related system variables

R parameters

Siemens cycles

Jog/handwheel increment factor

P: Data is read/written in the programmed measuring system

G: Writing/reading takes place in the configured basic system.

Read position data in synchronized actions

If a measuring system has not been explicitly programmed in the synchronized action

(condition component and/or action component) length-related position data in the

synchronized action are always read in the parameterized basic system.

/PG/Programming Manual, Fundamentals; List of Addresses

Basic Functions

Function Manual, 09/2011, 6FC5397-0BP40-2BA0

G2: Velocities, setpoint / actual value systems, closed-loop control

7.3 Metric/inch measuring system

Sinumerik 840d sl