Siemens SINUMERIK 828D Function Manual page 1445

Tool parameter Significance
Wear - tool shape
15 Radius 1/Length 1
16 Length 2
17 Radius 1
18 Radius 2
19 Angle 1 /
minimum limit angle
20 Angle 2 /
maximum limit angle
Tool base dimension / adapter dimension
21 Basic length 1
22 Basic length 2
23 Basic length 3
Technology
24 Undercut angle
25
Reserved
*
"Reserved" means that this tool parameter is not used and is reserved for expansions.
3D-face milling
Milling cutter types 111, 120, 121, 130, 155, 156 and 157 are given special treatment for 3D-face milling by
evaluating tool parameters (1 -23).
References
For more information about various tool types, see:
• Functions Manual - Basic Functions; Tool Offset (W1), Chapter "Tool type (tool parameters)"
• Programming Manual Fundamentals; Chapter: "Tool compensations" > "List of tool types"
• Functions Manual - Special Functions; 3D-tool radius compensation (W5)
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
*
Note
for 3D face milling
for 3D face milling
for 3D face milling
for 3D face milling
for 3D face milling
with 2D TRC contour tool.
for 3D face milling
with 2D TRC contour tool.
only for turning tools
W1: Tool offset
18.4 Tool cutting edge
1445