Signals From Operator Control Panel (Db19) - Siemens SINUMERIK 828D Function Manual

Z1: NC/PLC interface signals
19.1 Various interface signals and functions (A2)
DB19
DBX16.7 Active or passive file system
Signal state 0 or Active file system
edge change 1 → 0
Application with HMI Advanced always 1
example(s)
DB19
DBB17 PLC line offset in the user control file
Edge evaluation: No
Description This byte for controlling file transfer via the hard disk defines the line of the user control file in which
the control file to be transferred is located.
Application Valid for HMI Advanced, with reference to DB19 DBB13
example(s)
Dependent on:
DB19 DBX14.7=0 → Akt. FS: PLC line offset in a standard control file
DB19 DBX14.7=1 → Pas. FS: PLC line offset in a user control file
DB19
DBX44.0 Mode change disable
Edge evaluation: No
Signal state 1 or Mode change disable active
edge change 0 → 1
Signal state 0 or Mode change disable active
edge change 1 → 0
DB19
DBX45.0 FC9 Out: Active
Edge evaluation: No
DB19
DBX45.1 FC9 Out: Done
Edge evaluation: No
DB19
DBX45.2 FC9 Out: Error
Edge evaluation: No
DB19
DBX45.3 FC9 Out: StartError
Edge evaluation: no
19.1.5

Signals from operator control panel (DB19)

DB19
DBX20.1 Screen dark
Edge evaluation: No
Signal state 1 or The screen is darkened.
edge change 0 → 1
1620
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions