Siemens SINUMERIK 828D Function Manual page 1668
Hide thumbs
Also See for SINUMERIK 828D:
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages) ,
- Programming manual (822 pages)
Table of Contents
Advertisement
Z1: NC/PLC interface signals
19.6 Mode group, channel, program operation, reset response (K1)
DB11
DBX0.4
Mode change disable
Edge evaluation: No
Signal state 1 or
The currently active mode (JOG, MDA or AUTOMATIC) of the mode group cannot be changed. The
edge change
machine functions that can be selected within a mode group can be changed.
0 → 1
Signal state 0 or
The mode of the mode group can be changed.
edge change
1 → 0
DB11
DBX0.5
Mode group stop
Edge evaluation: No
Signal state 1 or
An NC stop is activated for all the channels of the mode group. The channel status of all the active
edge change
channels changes to the channel status "interrupted". All of the channels in channel status "reset"
0 → 1
remain in the channel status "reset". Programs that are running at this point are immediately
interrupted (at the earliest possible point, even within a block) and the program status changes to
"stopped". All the moving axes of the mode group are decelerated according to their acceleration
characteristics without contour violation. The program can be restarted with NC start. None of the
spindles of that mode group are affected.
Signal state 0 or
Channel status and program execution are not influenced.
edge change
1 → 0
Special cases,
All the axes of a mode group that are not triggered by a program or a program block (e.g. axes
errors, ... ...
traverse because traverse keys are being pressed on the machine control panel) decelerate to rest
with mode group stop.
DB11
DBX0.6
Mode group stop axes plus spindles
Edge evaluation: No
Signal state 1 or
An NC stop is activated for all the channels of the mode group. The channel status of all of the active
edge change
channels changes to the channel status "interrupted". All of the channels in channel status "reset"
0 → 1
remain in the channel status "reset". Programs that are running at this point are immediately
interrupted (at the earliest possible point, even within a block) and the program status changes to
"stopped". All the moving axes and spindles of the mode group are decelerated according to their
acceleration characteristics without contour violation. The program can be restarted with NC start.
1668
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions
Advertisement
Table of Contents
