Installing The Chassis Brackets; Installing The Chassis In The Rack - Cisco SCE 8000 Installation And Configuration Manual

Chapter 4 Installing the Cisco SCE 8000 Chassis

Installing the Chassis Brackets

The chassis is shipped with the mounting brackets installed on the front of the chassis. These brackets
can be installed on the rear of the chassis.
To install the brackets on the rear of the chassis, perform these steps:
Remove the screws that secure the brackets to the chassis. (See
Step 1
Figure 4-13 Brackets on Cisco SCE 8000 Chassis
FA N ST
SCE 8000
-SC M-E
AT U S
SC M 1
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
1000
SCE 8000
-SC M-E
SC M 2
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
1000
SCE 8000
-SIP
SIP 3
4
TX
SC E8 00
0- FA N
RX
Step 2 Position one of the brackets against the chassis side, and align the screw holes.
Step 3 Secure the bracket to the chassis with the screws removed in Step 1.
Step 4 Repeat

Installing the Chassis in the Rack

To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
Caution
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed to
support the weight of the unit. Lift the unit only by grasping the chassis underneath its lower edge.
To install the Cisco SCE 8000 chassis in the equipment rack, perform these steps:
Step 1 Position the chassis in the rack as follows:
•
•
STA TUS
LINK
ACT IVE OP TIC AL
BY PAS S
STA TUS
LINK
OP TIC AL
ACT IVE
BY PAS S
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
TX
TX
TX A C
CT RL
B
RX D
RX A B
C D
RX
ST AT US
OP TIC AL
BY PA SS OP B- SC
1 E8 K- MM
Step 2 and Step 3 for the other bracket.
If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between
the mounting posts.
If the rear of the chassis is at the front of the rack, insert the front of the chassis between the
mounting posts.
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
Cisco SCE8000 GBE Installation and Configuration Guide
Installing the Chassis Brackets
Figure 4-13.)
4-17