Removing A Module - Cisco SCE 8000 Installation And Configuration Manual

Removing a Module

While pressing down, simultaneously close the left and right ejector levers to fully seat the module in
Step 10
the backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate. (See
Note Failure to fully seat the module in the backplane connector can result in incorrect operation or error
messages.
Figure 9-13
FA N ST
SC E8 00
Tighten the two captive installation screws on the module.
Step 11
Make sure the ejector levers are fully closed before tightening the captive installation screws.
Note
Removing a Module
Before you remove a Cisco SCE 8000-SCM, you should first save the current configuration, if the
current configuration should be preserved and duplicated on the new Cisco SCE 8000-SCM-E. (Use the
copy running-config startup-config command.) This step saves time when bringing the module back
online. You can recover the configuration by downloading it from the server to the nonvolatile memory
of the Cisco SCE 8000-SCM-E.
When you install a new Cisco SCE 8000-SCM-E, check the factory default configuration. You might
Tip
need to reconfigure the system to your requirements. You can reconfigure the Cisco SCE 8000-SCM-E
manually, or if you previously uploaded the original configuration to a server, you can download it to
the new Cisco SCE 8000-SCM-E.
Cisco SCE8000 GBE Installation and Configuration Guide
9-20
Figure 9-13)
Ejector Lever Closure
SCE 8000
AT US -SCM -E
SC M 1
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000 OPT ICA
ACTI VE L BYP ASS
SCE 8000
-SCM -E
SC M 2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000
ACTI VE OPT ICA
L BYP ASS
SCE 8000
-SIP
SIP 3
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
4
TX
TX
0- FA N
TX
A C
RX TX CT RL
B
RX D
A B
RX
C
RX D
STA TU
OP TIC AL S
BY PA SS OP B-S
1 CE 8K -M
M
Ejector levers flush
with module faceplate
Chapter 9 Removal and Replacement Procedures
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2