Installing A Spa In A Sip; Removing A Spa From A Sip - Cisco SCE 8000 Installation And Configuration Manual

Installing a SPA in a SIP

Installing a SPA in a SIP
To install a SPA in a SIP, see
At the SCE8000# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000
Step 1
platform before installing or removing any module.
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at
Step 2
the top left and top right of the SPA slot and are recessed about an inch, as shown in
Carefully slide the SPA into the SIP until the SPA is firmly seated in the SPA interface connector. When
Step 3
fully seated, the SPA might be slightly behind the SIP faceplate.
After the SPA is properly seated, fasten the SPA in place with the captive installation screws.
Step 4

Removing a SPA from a SIP

To remove a SPA from a SIP, see
At the SCE8000# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000
Step 1
platform before installing or removing any module.
If attached, remove any cables from the SPA.
Step 2
To remove the SPA from the SIP, unfasten the captive installation screws on the SPA.
Step 3
Step 4 Grasp the handles of the SPA and pull the SPA from the SIP.
Cisco SCE8000 GBE Installation and Configuration Guide
9-32
Figure 9-17 and do the following:
Figure 9-17 and do the following:
Chapter 9 Removal and Replacement Procedures
Figure 9-17.