Unsupported Configuration - Cisco SCE 8000 Installation And Configuration Manual

Unsupported Configuration

Figure A-1
Subscriber
Figure A-2
Subscriber
In the preceeding configuration, it is essential that the Cisco SCE 8000 be operating in receive-only
Note
mode. Other configurations may cause SPAN port traffic to be returned to the switch, causing
unpredictable behavior.
Unsupported Configuration
With regard to the preceeding 10 GBE characteristics, the following configuration is not supported in
the 10 GBE environment as shown in
DOWN state and therefore does not transmit.
Figure A-3
Subscriber
Cisco SCE8000 GBE Installation and Configuration Guide
A-2
Supported Optical Splitter Configuration
Switch
Splitter
RX TX
3/0/0
3/2/0
Supported SPAN Port Configuration
Switch
RX TX
3/0/0 3/1/0
3/2/0 3/3/0
Figure
Unsupported SPAN Port Configuration
Switch
RX TX
3/0/0 3/1/0
3/2/0 3/3/0
Appendix A Using Optical Splitters with 10 GBE Links
Router
RX TX
3/1/0
3/3/0
Network
A-3. In this configuration, the switch port remains in the
Network
Network