Cisco SCE 8000 Installation And Configuration Manual page 31

Chapter 2 Introduction to the Cisco SCE 8000 10 GBE Platform
Table 2-3
LEDs
Power
Status
Optical bypass
Master
Port1 and Port2
(Management
interfaces)
Cisco SCE 8000-SCM-E LEDs
Description
• Green—Installed power supplies are functioning normally.
• Amber—Only one power supply is functioning normally.
• Unlit—No power from either power supply.
The Status LED indicates the operational status of the Cisco SCE 8000 10 GBE
system, as follows:
Unlit—No power from either power unit.
•
Amber—The system is booting up.
•
Flashing amber—The system is operational, but is in a warning state.
•
Green—The system is fully operational.
•
Red—There is a problem or failure
•
Alarms are hierarchical: Failure takes precedence over Warning, which
Note
takes precedence over Operational.
Green—Optic bypass modules are present, but not operating.
•
Amber—Optic bypass modules are present and operating.
•
Unlit—Optic bypass modules are not present or there is no power.
•
On a slave Cisco SCE 8000-SMC-E module (in slot 2), this LED is always off.
Note This functionality is consistent even when the Cisco SCE 8000 10 GBE is
turned off.
Master Service Control module indicator.
• Steady green—Master Service Control module (in slot 1)
Unlit—Slave Service Control module (in slot 2)
•
The Port1 and Port2 LEDs indicate the operational status of the Cisco SCE 8000
out-of-band LAN-based management port, as follows:
Link/Active
•
Steady green—Port link is up
Flashing green—Activity on the port link
Unlit—Port link is down
Speed
•
Unlit—Port is set to 10 Mbps
Steady green—Port is set to 100 Mbps
Steady amber—Port is set to 1000 Mbps
On a slave Cisco SCE 8000-SMC-E module (in the second slot), this LED is
always off.
Service Control Module (Cisco SCE 8000-SCM-E)
Cisco SCE8000 GBE Installation and Configuration Guide
2-5