Cisco SCE 8000 Installation And Configuration Manual page 13

Organization
The major sections of this guide are as follows:
Table 2
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Appendix A
Organization
Title
Cisco Service Control Overview
Introduction to the Cisco SCE 8000 10 GBE
Platform
Cisco SCE 8000 Topology and
Topology-Related Parameters
Installing the Cisco SCE 8000 Chassis
Connecting the Management Interfaces
Cabling the Line Ports and Completing the
Installation
Basic Cisco SCE 8000 Platform Operations
Troubleshooting
Removal and Replacement Procedures
Using Optical Splitters with 10 GBE Links
Description
This chapter provides a brief introduction
to Cisco Service Control.
This chapter provides a hardware
overview of the Cisco SCE 8000
platform.
This chapter describes the possible
deployment topologies of the Cisco SCE
8000 and explains how various aspects of
the topology determine the configuration
of the system.
This chapter explains how to install a
Cisco SCE 8000 platform in the rack and
properly ground it.
This chapter explains how to connect the
Cisco SCE 8000 platform to a local
console and perform the initial system
configuration via the setup wizard that
runs automatically.
This chapter provides instructions for
cabling the Gigabit Ethernet ports for
both one and two Cisco SCE 8000
topologies, and for configuring Gigabit
Ethernet (GBE) interface parameters. In
a topology utilizing two Cisco SCE
8000s (cascade), this includes the
cascade ports as well as the line ports.
This chapter describes how to start up the
Cisco SCE 8000 platform, reboot, and
shutdown. It also describes how to
manage configurations.
This chapter provides basic system
startup troubleshooting information.
This chapter explains the procedures for
removing and replacing the power
supplies, fan trays, and other modules.
This appendix supplies important
information about supported and not
supported optical splitter configurations
in the 10 GBE environment.
Cisco SCE8000 GBE Installation and Configuration Guide
3