Cisco SCE 8000 Installation And Configuration Manual page 107

Chapter 6 Cabling the Line Ports and Completing the Installation
Using the control cable provided, which has RJ11 connectors on both ends, plug one end into the CTRL
Step 3
interface on the external bypass module (see
interface on the Cisco SCE 8000-SCM-E in slot 1 of the Cisco SCE 8000 chassis (see item 1 in
Figure
bypass modules, use both External Bypass ports on the Cisco SCE 8000-SCM-E in slot 1.
Complete the installation and powering up of the Cisco SCE 8000.
Step 4
By its nature, the optic bypass module does not connect the link to the Cisco SCE 8000-SIP module until
the entire Cisco SCE 8000 system is fully functional. It is necessary to bring the Cisco SCE 8000 to fully
operational and non-bypassed status to confirm correct functioning of the link through the optic bypass
module to the Cisco SCE 8000-SIP module.
Step 5 Verify link connectivity by checking that the link LED on the 10 GBE interface is green, or by using the
Cisco SCE 8000 command line.
Figure 6-3
Figure 6-4
6-4). If using only one external bypass module, use External Bypass port 1. If using two external
Cabling the CTLR Interface on the External Bypass Module
T X
T X
T X
R X
T X
R X
R X
A R X
B
C
Cabling the Cisco SCE 8000-SCM-E Module
1
S C E 8 0 0 0
-S C M -E
O P T IC A
B Y P A S
S 1
Cabling the 10 GBE Line Interface Ports: Using the External Optical Bypass Module
Figure 6-3) and plug the other end into the External Bypass
A
C
B
D
C T R L
A
B
C
D
D
S T A T U S
O P B — S C
E 8 K — M M
2
3
L
C O N S O
L E
P O R T 1
1 0 /1 0 0 /
L IN K /
1 0 0 0
A C T IV E
Cisco SCE8000 GBE Installation and Configuration Guide
6-15