Installing An Optical Bypass Module - Cisco SCE 8000 Installation And Configuration Manual

Chapter 4 Installing the Cisco SCE 8000 Chassis

Installing an Optical Bypass Module

There are two installation options for the external bypass modules:
•
•
For external mounting, install the external mounting panel in the 19" rack. Screw the mounting panel to
Step 1
the rack using four 3/4-inch screws, two on each side, through the holes in the mounting panel and into
the threaded holes in the rack posts.
For internal mounting, the Cisco SCE 8000 chassis is shipped with the chassis mounting panel already
installed in slot 4.
Remove the module filler plate covering the subslot in the mounting panel by loosening the two screws.
Step 2
Carefully insert the optical bypass module into the subslot (there are no guide rails) and tighten the
Step 3
captive screws on either side of the module. (See
Figure 4-15
Chassis mount panel—This panel is mounted on slot 4 of the Cisco SCE 8000 chassis. It hosts two
optical bypass modules, which will serve the two traffic links supported by one
Cisco SCE 8000 chassis.
External mounting panel—This panel can be mounted in any 19" rack. It hosts up to four optical
bypass modules, which will serve the four traffic links supported by two Cisco SCE 8000 platforms.
Optical Bypass Modules in the External Mounting Panel
FA N ST SCE 8000
-SCM -E
AT US
SC M 1
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACTI VE
SCE 8000
-SCM -E
SC M 2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACTI VE
SCE 8000
-SIP
SIP 3
4
SC E8 00
0- FA N
Figure 4-15.)
STA TUS
OPT ICA
L BYP ASS
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
STA TUS
OPT ICA
L BYP ASS
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
Cisco SCE8000 GBE Installation and Configuration Guide
Installing an Optical Bypass Module
4-19