Cisco SCE 8000 Installation And Configuration Manual page 184

Replacing the Optical Bypass Module Without Disrupting Traffic on the Link
Remove the optical bypass module from the Cisco SCE 8000 chassis and immediately install it in the
Step 3
new Cisco SCE 8000 platform. Alternatively, it can be installed in an external mounting panel elsewhere
in the rack.
Connect the cables from the optical bypass module to the line interfaces of the new Cisco SCE 8000
Step 4
platform. See the
Cisco SCE8000 GBE Installation and Configuration Guide
9-34
"Optical Bypass Module Connectivity" section on page
Chapter 9 Removal and Replacement Procedures
6-9.