Cisco SCE 8000 Installation And Configuration Manual page 40

Optical Bypass Module (OPB-SCE8K)
Up to four optical bypass modules can be mounted using an external mount panel
(OPB-SCE8K-EXT-PNL). A single panel can serve two Cisco SCE 8000 platforms, each cutting two
links or up to four Cisco SCE 8000 platforms, each cutting a single link. The optical bypass module is
displayed in
bypass module LEDs.
Figure 2-8
Table 2-8
Port
10 GBE Line
port
CTRL
Table 2-9
LEDs
Status
Cisco SCE8000 GBE Installation and Configuration Guide
2-14
Figure 2-8. Table 2-8 lists the optical bypass module ports, and
Optical Bypass Module
A
B
TX TX TX TX A
C
RX RX RX RX
STATUS
A B C D
Optical Bypass Module Ports
Quantity Description
4 10 GBE ports A through D
Duplex LC, panel mount adaptor
for LC/UPC connectors
1 RJ-11 port
Optical Bypass Module LEDs
Description
The Status LED indicates the operational status of the optical bypass
module, as follows:
Green—Bypass module has been de-activated (traffic flows through the
•
Cisco SCE 8000 platform)
Off—Bypass module is active (traffic does not flow through the Cisco
•
SCE 8000 platform)
Chapter 2 Introduction to the Cisco SCE 8000 10 GBE Platform
C
CTRL
D
B
D
OPB—SCE8K—MM
Table 2-9 lists the optical
Connect This Port To
SPA interfaces on the Cisco SCE
8000.
See the "Cabling the 10 GBE
Line Interface Ports: Using the
External Optical Bypass
Module" section on page 6-14
for further information.
RJ-11 Optical Bypass port on the
Cisco SCE 8000-SCM-E.