Appendix B CLI Commands to Verify a Successful Installation
To check this
RDR formatter
Connection to Subscriber Manager
Connection to Quota Manager
Complete command sequence for a fully-populated Cisco SCE 8000 10 GBE platform using both the SM and the QM
SCE8000> enable 5
Password:<cisco>
SCE8000> show version
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
SCE8000>
CLI Command Output Samples
The text in bold in the following output samples indicates the lines you should check when doing a
post-installation check. For some commands, the output is short and the entire output is relevant. In these
cases, nothing is in bold.
Use this command
show RDR-formatter
show interface linecard subscriber
sm-connection-failure
show ip rpc-adapter sessions
show inventory
show interface TenGigabitEthernet 3/0/0
show interface TenGigabitEthernet 3/1/0
show interface TenGigabitEthernet 3/2/0
show interface TenGigabitEthernet 3/3/0
show system operation-status
show interface linecard 0
show interface linecard 0 connection-mode
show interface linecard 0 link mode
show interface linecard 0 external-bypass
show rdr-formatter
show interface linecard 0 subscriber sm-connection-failure
show ip rpc-adapter sessions
Comments
Verify the following:
•
RDR formatter has established a
connection with the configured
destinations.
Redundancy status is configured
•
correctly in case of more then one
destination.
If using SM, verify that the connection
with the SM is established.
If using QM, verify that the connection
with the QM is established.
Cisco SCE8000 GBE Installation and Configuration Guide
CLI Command Output Samples
B-3