Cisco SCE 8000 Installation And Configuration Manual page 37

Chapter 2 Introduction to the Cisco SCE 8000 10 GBE Platform
Table 2-7
LEDs
Active/Link (1)
Status (2)
SPA LEDs
Description
• Green—Port is enabled by software and the link is up.
• Amber—Port is enabled by software and the link is down.
• Unlit—Port is not enabled by software.
The Status LED indicates the operational status of the SPA module, as
follows:
Green—SPA is ready and operational.
•
Amber—SPA power is on and good, and SPA is being configured.
•
Off—SPA power is off.
•
The 1-Port 10 GBE SPA Interface Module
Cisco SCE8000 GBE Installation and Configuration Guide
2-11