Chapter 4 Installing The Cisco Sce 8000 Chassis; Introduction - Cisco SCE 8000 Installation And Configuration Manual

Installing the Cisco SCE 8000 Chassis
Revised: August 26, 2014

Introduction

This chapter describes how to install a Cisco SCE 8000 chassis.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning There is the danger of explosion if the battery is replaced incorrectly. The battery is not a
user-serviceable part.
Statement 1015
Warning Class 1 laser product.
Statement 1008
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 1056
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information
Note
for the Cisco Service Control Engines (SCE). This guide contains important safety information you
should know before working with the system.
C H A P T E R
Cisco SCE8000 GBE Installation and Configuration Guide
4
4-1